OxyGreen Solutions has decades of mold experience coupled with the development of our patented technology that continuously improves.

The result is a complete expert system to properly remove the presence of mold and remediate contaminated areas.

Seemingly eliminating your issue can easily become a much more expensive problem when the proper steps are not taken to begin with.

OxyGreen Service Technicians take those necessary steps to save you money by solving your mold problems the first time.

To understand your mold problem, let’s cover the basics. Mold loves moisture. The moisture source must be identified and corrected. As for the stains, what you see are fungal mold colonies on the surface of the affected areas. What you can't see is even more dangerous. The microscopic mold spores are or become airborne and act like seeds leading to new fungal mold colonies. These colonies grow roots (Rhizoids) that penetrate deep below the surface.

While the moisture issue is being resolved, we isolate the space to be treated from the rest of the house or building. Next, we kill the surface colonies and airborne spores before anything is disturbed. Damaged materials such as drywall and carpet are removed for disposal. Mold stains are removed from wood and then our Oxy Green process penetrates into the substrate to destroy the mold roots which can be embedded 3/16 of an inch deep. This step not only prevents all hosts of decay and dry rot fungi but also prevents future wood boring insects such as carpenter ants, beetles and termites. The final step of our process permeates the entire area otherwise not reachable by traditional methods.

Most mold companies use anti-fungal cleaning chemicals that are harmful to humans and leave behind residual contaminates. These chemicals do not penetrate to the roots and do not kill spores. Some companies take the natural route and use products that contain thyme oil which also does not reach the roots or kill the spores. The OxyGreen System takes care of both problems without leaving behind harmful chemicals.

Another common method other companies use is to blast the surface with baking soda (very messy), or dry ice driven by compressed air. Again, afterwards what you see looks clean as if the problem is solved. The truth is blasting doesn't penetrate deep enough into the substrate to reach the root system. At the same time it sends an army of microscopic spores into the air exponentially compounding the infestation. Another problem commonly unaddressed is the presence of mold spores in other areas such as the HVAC air duct system. Our OxyGreen System kills mold and mold spores in those areas as well.

For Assistance: (865) 236-1030